Präzise Hunting Clamp Adapter
The clamp adapter is intended for mounting on the rifle scope.
It is slid over a length of 40 mm (or 35 mm for KH-30 to KH-38) over the objective of the rifle scope and screwed there. It stays permanently on the rifle scope. Mounting requires an air clearance of 4 mm between the scope and the barrel, with our clamp adapter adding 3.5 mm. For extremely flat mounted riflescopes, we offer a "Low Scope" clamp adapter with a diameter of 62 mm, it has a recess in the direction of the barrel root.
The overall diameter with clamp adapter to 61 mm lens diameter is 65 mm at the washer.
Protective film is applied to the mounting surfaces of the clamp adapter for the target of the rifle scope, which prevents damage to the rifle scope and increases its grip. As a result, the clamp adapter and thus the attachment itself will not be pulled away from the rifle scope at strong calibers.
A special inner contour ensures exact alignment of the attachment to the rifle scope. The bayonet at the front of the clamping sleeve is the basis for absolutely repeatable alignment of an attachment with each new mounting.
The clamp adapter is made of one piece of high-quality aluminum and protected from corrosion and wear by a hard elox coating.
We - Präzise Jagen - expressly point out that a front sight may only be mounted on the weapon if the legislation of the respective country allows it.
Mounting is at your own risk and responsibility.
